Thank you. This document has been successfully flagged as inappropriate. If warranted, appropriate action will be taken
The document category has been successfully changed
Public Pages |
LED chaser using Arduino
File: LED chaser using Arduino
File Category: Instructional Guide
This LED Multi Pattern of Blinking effect is done by using the arduino UNO. This circuit connection is very very easy and simple because of arduino board is used. The effect is very beautiful with multi style of patterns. Here only 10 LEDs are used but you can connect upto 12 LEDs.
2-13 Digital pin of Arduino is connected with the LEDs positive terminal through 470 ohm resistor and Ground connection is connected with GND pin near the pin no 13 of Arduino. Here i used only pin 2-11 so i used programming for pin 2-11. but you can add instruction in programming for pin 12 and 13 as same as pin 11. if you want to connect high load bulb, then you can use 5v Relay through NPN transistor and connect the high load AC bulb.
Video link https://www.facebook.com/1828100427483348/videos/2280260178874735/
For More details and coding go to
Post Edited Successfully
This document has been saved successfully to your saved documents